钢结构施工 建工作总结.doc

杨凌职业技术学院 “教学质量提升与教学改革工程”项目建设工作总结 (2011年度) 项目名称《钢结构工程施工与组织》课程建设 项目类别 省 级 精 品 课 程 立项时间 2010年7月 负 责 人 刘 洁 所属院系部（盖章） 建筑工程学院 联系电话 杨凌职业技术学院教务处制 二〇一二年三月 一、项目建设目标完成情况及主要做法课程效果显著课程课程课程所需的知识、技能、态度按照岗位标准，完善课程标准知识与技能体系施工的编制、进度控制、安全管理等管理理论与管理方法融入过程中，。 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force, and c