PS制作雾的效教程,新手可以学习一下.doc

本帖最后由 bignjin 于 2012-11-23 14:43 编辑看到有很多同学不会在效果图中，尤其是鸟瞰图中添加本雾效，本人制作此教程，其实过程挺简单的，主要用到了云彩滤镜和蒙版，就以故宫为原始图片吧！ 2008718125838610_2[1].jpg (510.44 KB, 下载次数: 61) 选用故宫这张图 11.jpg (401.6 KB, 下载次数: 33) 设置前景色与背景色是为了下面使用滤镜时用的，然后新建图层 22.jpg (343.58 KB, 下载次数: 28) 33.jpg (319.63 KB, 下载次数: 30) 44.jpg (243.04 KB, 下载次数: 21) 多做几层，一般3到5层就可以了 55.jpg (207.79 KB, 下载次数: 20) 66.jpg (216.95 KB, 下载次数: 30) 添加蒙版用不同不透明度的黑色柔角笔刷涂抹 7.jpg (288.3 KB, 下载次数: 27) 根据需要可以得到各种雾化效果 the drawings, first to become familiar with the drawings, mainly about the following aspects: 1) pages of drawings and diagrams, maps; 2) a comprehensive understanding of drawing; 3) finding of design-driven dimensions (), do not resize and adjust the size; 4) questioned the drawings; 5) develop buries a construction programme and technical clarification; 6) clear corners and special treatment; 7) controlled construction drawings to verify construction scheme and design. (2) at the construction site to find subject planted area: various engineering, first on the scene to find planted area, it must first understand the curtain wall installation section, and some projects are all curtain wall, the entire project is a region-wide, only partial walls, the zone is local. (3) identify the axis positioning: positioning the drawings shown in axis compared with the actual construction site to find out exactly where the axis positioning, axis positioning function are: 1) to help determine the origin of curtain walls; 2) acceptance of the installation is accurate; 3) adjust errors, and determine the error range. (4) find anchor points: according to site to find the exact location of the axis, according to the drawings provided by the content determine the positioning point; number of anchor points shall not be less than two points. Repeated measurements determine the location points must ensure that the positioning is correct. (5) take level (level): level (minor works available in horizontal pipe), the two anc