ps设计蓝色发字效果.docVIP

ps设计蓝色发光字效果 作者：网络运营中心　文章来源：河南新华电脑学院 新建大小900X366 填充黑色 图层样式 设置如下 得到下图效果 新建图层 用距形工具 填充黑色 如下图 填充不透明度为O 渐变样式如下 得到效果 如下 打出你要打的字!不解释 样式如下 设置不透明度 为0 得到下图效果 然后复制这个图层 把复制的图层 样式 做一点改动 字体效果就出来了! 新建图层 在用矩形工具做出如下图的椭圆形 然后高撕模糊在动感模糊 样式为叠加 如图 在建个图层用矩形填充白色 填充不透明为0 图层样式如下 效果如下 在用矩形工具羽化8，祛除边缘，效果就出来了 最后在加些笔刷装饰，最后效果就出来了。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and