库尔楚中学党支党员公开承诺践诺台账.docVIP

库尔楚中学党支部党员公开承诺践诺台账 序号 党员姓名 承诺事项呢 践诺情况 完成时间 1 贾艳春 1加强校园文化建设；2.勤勤恳恳，踏实认真。加强政治理论学习。.积极做好教学工作，培养学生良好的学习习惯2. 深入教研组不断提高教学研究水平。 1.开展扶贫助学活动。 2.做好教研组工作，力争先进教研组。 .潜心钻研教材，认真上好每一节课。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell down, causing an open circuit. After wiring, may be tried. E, crimping Terminal crimping, wire and Terminal contact is good, solid, not subject to mechanical strain,