软件安装步骤如下 将已拷入升级软件的U盘与机器连接，然后通电.docVIP

软件安装步骤如下 将已拷入升级软件的U盘与机器连接，然后通电，开机，机器成正常开机状态。 进入如右图所示的主界面 3. 进入Application 后显示如右图界面 点击进入 firmware ,如下图所示 4. 在Browse 中找到要升级的软件如下图所示，并选择需升级的软件， 5.点击Upgrad now, 6.继续点击OK键开始升级 7.升级开始时时显示如下界面 8.升级需要1分钟左右，升级过程中注意千万不能断电，以免损坏机器中的软件。 升级完成后，会自动返回主界面 知道电视出现下图所示的界面，升级过程才算完成，这时可以断电。 The upgrade setup of this network player copy the new softeware to the root path of your USB drive , then connect the USB drive to the player. Open the player , you can see the Home screen like the picture 1. Picture 1. Choosing Application, then enter, you can see the screen like picture 2 Picture2. Choosing Firmware, then enter, you can see the screen like picture 3 Picture 3. You need choose Browse, find the new upgrade software,then begin to upgrade the player . when you upgrading ,you can see the screen like picture 4. and picture 5 Picture 4 Picture 5 It is need about 1 minute to upgrading the player , when you upgrading, please keep the power on it’s very important0. You shouldn’t turn off the power except the screen like picture 6 Picture 6 When you see the screen like picture6 , it meanse you finished upgrading,