ARM7编程案例.docVIP

Example program to show how to send characters out of UART0 by polling. Char- acters are sent out at rate of 1 every 10milliseconds. The data to be trans- mitted is stored in a static string that wraps to beginning when the last char- acter in the buffer is sent. This example does not use the PLL to mulitply the main clock frequency, so the main bus is running at 12MHz and the peripheral clock at 3MHz. Notice that in this example, the statement VICVectAddr = 0; which is necessary to signal the completion of an interrupt service routine, has been moved to the __irq function. If you have a lot of interrupt sources, this saves redund- ancy in code. The foreground task transmits the characters every time the 50msec timer expires. Use hyperterm or other terminal emulator with no flow control. 9 Jun 05 Usage note: if you do not see characters on hyperterm, halt the program by clicking on the red hand, then restart. 10 Jun 05 Enabling FIFO buffers with U0FCR = 1; per Anders Lundgrens advice. 20 Oct 08 Adapt for Micro-Blox LPC2148 board. Change from UART1 to UART0 Please set jumplers: On Main board J13 - 2-3 J14 - 2-3 J48 - filled J49 - 3-4 J50 - 5-6 On CPU board J3 - 1-2 J4 - 1-2 J9 - 1-2 J10 - 1-2 J24 - filled ******************************************************************************/ #include demo.h int main(void) { SoftwareTimer_t *ptr2Timer = softTimer[0]; char *ptr2Str = textString[0]; initializeInterruptDataStructs(); installTimer(ptr2Timer,FIFTY_mSEC_TIMER,TICKS_PER_50mSEC, // install 50msec FIFTY_mSEC_TIMER_INSTALLED); // sware timer /* Init MCU Clock */ /* Fosc = 12MHz, Fpckl = 12MHz */ PLLCON_bit.PLLC = PLLCON_bit.PLLE = 0; // Disable and disconnect PLL feed(); // PLL feed sequence /* Init Peripherial divider Pckl = Clk/4 */ VPBDIV_bit.VPBDIV = 0; /* This section of code configures Timer 0, match channel 0 to interrupt on matching the value stored in MR0 */ T0IR=0xFF