for complex difficult to measure the geometry of the workpiece.docVIP

for complex difficult to measure the geometry of the workpiece. 7. Other test methods. Include: large workpiece metallographic analysis; The ferrite content inspection; Spectral analysis; Portable hardness test; Acoustic emission testing, etc. 8. The application of NDT The selection of pressure vessel welding joint quality inspection method requires: (1) pressure vessel wall thickness less than or equal to 38 mm, the butt joint should use the X-ray testing, due to reasons such as the structure, not using radiographic testing, allowing a recordable ultrasonic testing. (2) the container wall thickness is more than 38 mm (or less than 38 mm, but more than 20 mm, e. lower limit and tensile strength is greater than or equal tompa), the butt joint, such as using radiographic testing, then each of the ultrasonic testing of welds shall also attach local local detection ratio for 20% of the proportion of the original testing, additional testing should include all weld cross area. There is a requirement for nondestructive testing (3) the Angle joint, tee joint, cannot undertake rays or ultrasonic testing, should be doing 100% surface detection. (4) the surface of the ferromagnetic material pressure vessel inspection should first choose magnetic powder. (5) the butt joint nonferrous metal pressure vessel should be used as far as possible ray detection. 1 h413000 industrial electrical engineering installation technology 1 h413010 mechanical equipment installation technology 1 P068 1 h413011 mechanical equipment foundation types and acceptance requirements A, the types and application of equipment foundation (a) material composition of different types of equipment foundation and application 1. The concrete foundation Composed of sand, stone, cement and other materials, suitable for small bear loads, deformation small equipment foundation. 2. The reinforced concrete foundation By sand, stone, cement, steel and other materials, the basis of applicable