上海贝尔GPO-e8c桥接改路由方法.docVIP

GPON－E８C设备（I-120E-Q、I-240W-R?、I-240E-Q）注册成功后，如需e8c作为宽带拨号路由器（网关）做如下修改： 前提是：设备注册时，提示：“注册成功，业务下发成功”的web提示，再做如下桥接改路由的配置： 1、在IE地址栏输入IP：192.168.1.1，通过用户名：telecomadmin 密码：nE7jA%5m （如果密码被itms修改了，需上报sn码给网维查密码）登录终端； 2、网络-宽带设置 如下图： 3、WAN连接列表：选择“2_INTERNET_B_VID_41”修改如下参数： “连接模式WAN IP 模式”Keep alive time”请选择“60”。一定按“确定”保存数据。 修改完成的数据如下图： 查看一下修改好的，接口状态： 注明：如果e8c与olt同步且，业务下发成功，上图中的红色圈中会有02088888888@163.gd拨号成功后，获取的公网地址！ 用户电脑搜索SSID为“ChinaNet- weQf”的WIFI信号，连接之即可无线上网（WIFI密码可查看E8-C终端底部标签，或登录终端管理界面“网络”—“WLAN配置”下查看： equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power