路虎实验报告.docxVIP

关键实验要求：实验内容包括原材料试验、电镀件性能试验、总成性能试验 Key experimental requirements: experimental test content, including raw materials, plating performance test, performance test assembly零件标识 Parts identification产品背面刻有配套厂家Logo、代码及时间章及客户LogoProducts back engraved with supporting manufacturers Logo, codes and time stamp and customer Logo 要求供应商每批国货的零件都必须有清楚的标识 标识位置及方式以图纸要求为准如果在预批量阶段不可能按图纸要求的方式进行标识，必须贴标签 Require suppliers to each batch of domestic parts must be clearly markedIdentify the location and manner in drawings by drawing prevail if it is impossible to identify the way in the pre-batch phase, must be labeled9.2 零件状态标识 /?tr=fhl=zh-CN/?tr=thl=zh-CN取消javascript:void(0)Part state identification在认可检验结束前，要在零件背面用黄色圆形标签标注零件状态 并将更改的内容记录在零件履历表中 头部有波浪，且左下右上有卡扣拉白现象模具頂出机构不平衡导致关模后拉白情況.进胶口偏小，在注塑过程中损失注塑压力，头部有波浪縮水现象 1.对卡扣进行拋光，建议更改現有的顶出机构，由顶针改制滑块 2对进胶口放大 在模具开发前期要求模具做模流分析，对這类細长的产品頂出机构建议考虑用顶块來实现Approved before the end of the test, in the back part to the label with a yellow circle part statusAnd content changes are recorded in parts of the curriculum vitaeThe head wave, and left the upper right there is a snap to pull white phenomenon1. The top of the mold clamping mechanism imbalance pull white case2. The intake plastic mouth is too small, the loss of pressure in the injection molding process, the head shrink wave phenomenon3. 1. snaps polished recommend changes to the existing top of the organization by restructuring the slider thimble4.2 pairs into the plastic mouth enlarge5. Early in the mold development requirements of the mold do mold flow analysis, the product of such an elongated ejection mechanism proposed to consider with the top block to achieve下长光亮条电镀时容易脱落，浇口易断裂/?tr=fhl=zh-CN/?tr=thl=zh-CN取消javascript:void(0)Under long bright bar when the plating off easily breakable gate电镀挂脚壁厚较薄，需要加强三处浇口处进行加强处理Plating Rack thin wall thickness, the need to strengthenThree to reinforce the gate processing1、在产品设计时要充分考虑电镀时的挂脚固定问题 2、挂具在设计时要考虑产品形状及挂脚尺寸，防止挂具和产品装配不匹配。 产品装配LOGO后焊接点不牢固，评估有脱落风险 /?tr=fhl=zh-CN/?tr=