贴片机Cm培训记录.pptVIP

DAIICHI JITSUGYO (Philippines), Inc. X- AXIS MOTOR ORIGIN Y- Axis Motor Origin Head Assembly Removal Spline shaft replacement( Option 1 ) Spline shaft removal( Option 2 ) Theta motor/ belt replacement Line Camera removal / Adjustments Head camera replacementand Adjustments * 1. Serviceman mode/ Debug parameter/ Exclusive Of all origin “ON” Reduce the value of the following parameter to slowdown the motor rotation.(1/3 of its original value) 2.1 Position Ctrl Gain 2 (1/3 of original value) 2.2 Speed Ctrl Gain 2 (1/3 of original value) 2.3 M/C Resonance Controll Fill. ( set to “0” zero) Centering jig Go to Axis move/ Origin X-motor Manually sense X-axis origin sensor to attain origin state. Set the X- axis stopper Jig for X-axis motor. Set the coupling jig between the the ballscrew and motor shafts. Stopper Jig for X- axis DAIICHI JITSUGYO (Philippines), INC. 1. Serviceman mode/ Debug parameter/ Exclusive Of all origin “ON” Reduce the value of the following parameter to slowdown the motor rotation. 2.1 Position Ctrl Gain 2 (1/3 of original value) 2.2 Speed Ctrl Gain 2 (1/3 of original value) 2.3 M/C Resonance Controll Fill. ( set to “0” zero) Go to Axis move/ Origin Y-motor Manually sense Y-axis origin sensor to attain origin state. Set the Y- axis stopper Jig for Y-axis motor. Set the coupling jig between the the ballscrew and motor shafts. Set the coupling after aligning the motor and ballscrew shafts. Pull The X-axis beam until it come into contact with the stopper. Tighten coupling while maintaining the contact position. DAIICHI JITSUGYO (Philippines), INC. Power OFF machine and drain out air supply. Remove Head cover to expose connectors and air lines. 3. Disengage connectors and air line(s). 5. Remove allen bolts (with special stopper) and pull out head assembly. Allen bolt with stopper Head assembly disengaged from machine. 4. Remove camera connectors/ grease tubes DAIICHI