11_CAT513_r13_WS1.ppt

WORKSHOP 1 WORKSHOP 1 Suggested Exercise Steps Start a new V5 Part (.CATPart). Set length units to millimeters. Modify Sketcher grid settings (primary spacing: 50 mm, graduations: 10), display grid and activate snap to point. Begin a new sketch on the xy plane. Sketch the outer profile of the bracket utilizing grid spacing. Complete the profile by adding corners. Create the solid part. Begin a new sketch on the top surface of the solid part. Sketch the inner profile of the bracket. Complete the inner profile by adding corners. Add a pocket to the part. Edit Sketch.1 by accessing the Sketcher w