unquaified welds should be repair.docVIP

unqualified welds should be repair, repair should be stipulated in the original after checking. Each weld overhaul shall not be more than 2 times. 4.4 the flange and valve installation Valve inspection Valves are used in the heating pipe network engineering, must have a factory product certificate and engineering seat valve inspection department inspection qualified certificate; Without the project the valve seat valve inspection department, should according to the current national standard pipeline engineering construction and acceptance standard test (GBJ235); Heating pipe network used in the main valve and directly connected to heating network main valve; Trunk and head end and thermal protection stand at the entrance to the closed and the valve strength and leak test shall be carried out individually, separate storage, positioning, and fill the valve test record. The valve installation Proofreading as stipulated in the design model, the valve appearance inspection should be no defect, flexible open and close; Remove valve mouth closed (or file) and other impurities; The handwheel should be put in to operation of valve position. Horizontal installation of the valve is in the upper within weeks. The valve should be installed under the closed; Valve operating mechanism and transmission should be cleaning check and adjustment, flexible, reliable, and no jamming phenomenon, switch indication degree should be accurate; Cluster installation of the valve should be according to the principle of neat, beautiful, easy to operation for ranking; The valve handwheel shall not be used as lifting ChengChongDian. 4.5 compensator installed and cold, hot tight tight The installation of the compensator is: The arm should be placed in horizontal, vertical, parallel arm should be the same as the pipe slope; Vertical installation, do not open the hole on the bent pipe installation put duct and drain; Compensator in the slippery of offset should comply with the provisi