《毕业设计(论文)-2.2KW交流电动机串级调速系统设计》.docVIP

2.2kw交流电动机串级调速系统设计 摘 要 串级调速是通过绕线式异步电动机的转子回路引入附加电势而产生的。它属于变转差率来实现串级调速的。与转子串电阻的方式不同，串级调速可以将异步电动机的功率加以应用（回馈电网或是转化为机械能送回到电动机轴上），因此效率高。能实现无级平滑调速，低速时机械特性也比较硬。特别是晶闸管低同步串级调速系统，技术难度小，性能比较完善，因而获得了广泛的应用。：异步电动机串级调速原理基本类型2.2kw alternating current motor concatenation control system design AbstractCascade speed through the Wound-rotor induction motor circuit and the introduction of additional potential generated. It is a change to slip to achieve the Cascade governor. And the rotor string resistance in different ways, cascade speed asynchronous motor can be applied in power. (Grid or feedback into mechanical energy sent back to motor shaft), high efficiency.The so-called double-fed governor, refers to power were fed into the induction motor stator windings and rotor winding. Usually stator windings access frequency power supply, will be received rotor winding frequency, amplitude, phase and phase sequence, we can adjust asynchronous motor torque, speed and motor stator side of the reactive power.This double-fed governor of the induction motor can be super-synchronous and sub-synchronous operation, not only can work in the electrical state, but can also work in the state of power generationIt can achieve a smooth-speed, low speed when the mechanical properties are relatively hard. SCR especially low speed synchronous cascade system, the technical difficulty of small, relatively sound performance and thus access to a wide range of applications. Keywords: Asynchronous motor; Cascade Speed; Principle; Basic types目 录 摘 要 I Abstract II 第一章 概 述 1 1.1交流电动机调速的发展概况 1 1.2 串级调速的优缺点 2 1.3 与变频调速方式的比较及应用 3 第二章 双闭环控制的串级调速系统设计 4 2.1双闭环控制串级调速系统的组成 4 2.2串级调速系统的动态数学模型 5 2.3 调节器参数的设计 8 2.4串级调速系统的起动方式 9 2.5 异步电动机串级调速时的机械特性 11 2.6 异步电动机串级调速时的转子整流电路 13 第三章 串级调速系统主回路主要参数计算与选择 17 3.1 异步电动机容量的选择 17 3.2 转子整流器的参数计算与元件选择 17 第4章 电流环和转速环设计 29 4.1 电流环的设计 29 4.2 转速环的设计 31 第五章 交流串级调速系统的仿真 34 5.1 MATLAB简要介绍 34 5.2晶闸管串级调速系统的建模与仿真 35 5.2.1系统的建模和参数设置 35 5.2.2系统的仿真参数设置 38 5.2.3 系统的仿真，仿真结果的输出及结果分析 38 第六章 结束语