《毕业设计(论文)－支撑板弯曲模设计》.doc

XXXX学院毕业设计 中文摘要 PAGE PAGE I XXXX学院毕业设计（论文） 支撑板弯曲模的设计 学 生： 学 号： 专 业： 班 级： 指导教师： XXXX学院材料与化学工程院 二OO九年六月 XXXX学院毕业设计 中文摘要 PAGE II 摘 要 本文介绍了国内外冲压模具的研究和发展状况，分析了冲压成型的特点。根据支撑板工件的设计要求，进行了弯曲模具设计的前期准备工作，制定了支撑板的弯曲工艺，并对模具零件进行了相关尺寸计算。根据计算结果选择了合适设备，绘制了支撑板弯曲模零件图和装配图，并提出了有关技术要求，同时详细阐述了支撑板弯曲模零件的设计过程。 关键词：支撑板弯曲模，冲压, 模具设计，零件图，装配图 XXXX学院毕业设计 英文摘要 Abstract The research and development of stamping moulds at home and abroad were introduced and the characteristic of punch forming was analyzed in this paper. According to the design requirements of support plate flexure mould, the preparation of designing moulds has been done. The bending process of support plate was drawn up, and the size of related parts was calculated. According to the calculation results, the suitable equipments were selected and the assembly and part drawings were drawn. The relevant technical requirements were proposed, and the design process of bending die parts for support plate was discussed. Keywords：Flexure mode of facing bar, Stamping, Mold design, Part drawing，Assembly drawing XXXX学院毕业设计 目录 PAGE IV 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc232794914 摘 要 PAGEREF _Toc232794914 \h I HYPERLINK \l _Toc232794915 Abstract PAGEREF _Toc232794915 \h II HYPERLINK \l _Toc232794916 1 绪 论 PAGEREF _Toc232794916 \h 1 HYPERLINK \l _Toc232794917 1.1 冷冲压加工概述 PAGEREF _Toc232794917 \h 1 HYPERLINK \l _Toc232794918 1.1.1 冷冲压加工工序的分类 PAGEREF _Toc232794918 \h 1 HYPERLINK \l _Toc232794919 1.1.2 冷冲压加工的工艺特点 PAGEREF _Toc232794919 \h 1 HYPERLINK \l _Toc232794920 1.2 我国冲压模具的发展现状 PAGEREF _Toc232794920 \h 2 HYPERLINK \l _Toc232794921 1.2.1 模具CAD/CAM技术状况 PAGEREF _Toc232794921 \h 2 HYPERLINK \l _Toc232794922 1.2.2 冲压模具设计与制造能力状况 PAGEREF _Toc232794922 \h 3 HYPE