模具结构简析_20160621课件.pptVIP

The main reason we add ribs to a part is to increase its stiffness. When you design a plastic part, we recommend that you avoid putting ribs as much as possible. After prototyping the part, add them accordingly. The main reason we add ribs to a part is to increase its stiffness. When you design a plastic part, we recommend that you avoid putting ribs as much as possible. After prototyping the part, add them accordingly. The main reason we add ribs to a part is to increase its stiffness. When you design a plastic part, we recommend that you avoid putting ribs as much as possible. After pr