第二课 相机前壳分叉面.pptVIP

第二課 相機前殼分叉面  (crotched surfaces) 【L2_0】 1.《Open File》: camera_L2.wire. 2. Make the Back Surfs layer invisible. Step2: Creating new boundary  curves 1.《New Curve (edit pts)》[ Knot Spacing: Uniform ; Curve Degree: 3 ] 2. Draw a curve and drag it’s ends to specific position.【L2_s2-2】 3.《Trim》the surface and “discard” the left-front area. 【L2_s2-3】 4. Draw another curve. 【L2_s2-4】 Step3: Adjusting curves 1. Select both the last CVs of the two curves and move them to “r0,0,-4. 【L2_s3-1】 2. Select both the 3ed CVs of the two curves and move them to “r0,0,-1”. 【L2_s3-2】 3. Set《Project Tangent》to the start end of the short curve with the “Front top” surface. 【L2_s3-3】 Step4: Creating a new surface 1. 《Untrim》the “Front top” surface. 2. 《Square》[ Boundary1 Continuity: Tangent ]. 【L2_s4-2】 3. Delete those two curves. 4. Set the “Front top” surface’s《Patch》to “a2” and make it template. 【L2_s4-4】 Step5: Adjusting the shape of the new surface 1.《Insert》two “isoparams” to the new surface at U0.75 and U0.62 (by using hot-key “Alt” to snap to the position). 【L2_s5-1】 2. Display CVs and Hulls. 【L2_s5-2】 3. Pick the last hull and move it to “r0,0,-3”【L2_s5-3】 ( Step5: Adjusting the shape of the new surface ) 4. Pick nothing. Then, pick the hull next to the last hull and move it to “r0,0,-1.5”. 【L2_s5-4】 5. 《Extend》right boundary 5mm. 【L2_s5-5】 6. Hide CVs and Hulls. Step6: Re-intersecting and  trimming surfaces 1. Toggle the “Front top” surface from template to pickable and remove those two CrvOnSrfs. 2.《Untrim》the “Front right”, “Front fa?ade” and “Front handle” surfaces. 【L2_s6-2】 3. Select 3 CrvOnSrfs and delete them. 【L2_s6-3】 4. From top view,《project》new surface’s boundary to the “Front top” surface. 【L2_s6-4】 ( Step6: Re-inters