易拓母线安装维护作个业d指导书.docVIP

装卸、储存指导手册 01 Loadunload and storage Instruction ■ 使用合适的装卸设备进行装卸，避免损坏内部的元件和附件，建议采用叉车装卸。 ■ 在搬运母线槽单元时，必须两个端部同时搬运，不可以将母线槽的端头作支点搬运母线 槽，不可在地面上或槽体之间拖拉母线槽。 ■ 所有母线槽应储存在一个干净、干燥的空间，远离灰尘，预防烟雾、水和化学性腐蚀。 ■ 储存场所一般应远离通道，避免阻止通道的畅通。 ■ 通常母线槽不应在室外储存，必须在室外储存时，应采用防水物完全覆盖好，远离污染物，避免阳光曝晒。 ■ 安装结束前，户外母线槽应与户内母线槽同等对待，直至安装完毕。 ■ 母线槽的堆放应以适当的，等截面、等体积木料支架来堆放，支架应放在母线槽中后部适当位置，以确保母线槽受力均衡。 ■ Use the suitable tool and avoid the damage of the internal components and accessories.Advise to choose fork-lift. ■When moving the busbar unit, the two terminals should be lifted at the same time. Dont move the busbar with one terminal and the other as the fulcrum. Dont drag on the ground or between the busbar units. ■ All the busbar should be stored in a clean and dry space. Keep away from the dust. Prevent from the smog, water and chemical corrosion. Dont loose the unit. ■ Keep away from the passage.  ■ Normally, the busbar shouldnt be stored outdoors. If it has to, cover the product by waterproof material. ■ Treat the outdoor busbar same as the indoor one until the finish of the installation ■ Place wood support (same cross-section, same volume) at the middle-back suitable position of the busbars to make sure the pressure is even. 安装指导手册02 Installation Instruction 一 母线槽安装前的对土建工程的要求 ■ 基础、构架、预留孔洞及预埋件符合电气设备的设计要求 ■ 屋顶、楼板施工完毕，不得有渗漏 ■ 室内地面施工完毕，并在墙上标出地面抹平标高线 ■ 基础、构架达到允许安装的强度 ■ 有可能损坏已安装母线槽的装饰工程全部结束 ■ 安装母线槽相关的场所应具备防盗措施 I. The substructure requirements before intallation ■ Substructure, truss, obligate hole, preparative embedding Parts meet the designing requirements of electric equipments. ■ Roof, floor construction finished, no leak. ■ Flooring construction is over and mark level line on wall. ■Substructre, truss reach the intensity of installation. ■All the ornament which may damage busbar should be finished. ■The door and windows installed completely on the area related to busbar should be full equipped. 二、安装准备阶段 安装前的人员选择及培训 1、母线槽的安装、操作和维修保养应该由专业的员工进行 2、