DFM案例讲述.pptVIP

1.0MM 1.5MM 6.0MM 第二色单咀尖点式进胶，增加一段胶位辅助进胶，尺寸如下图所示。 Second shot:HRS drop(tip) into part ,and add a length of plastic to contribute melt filling as indicated in the picture. Suggest to create a runner on top of the 1st shot for gating. Gate size 1.5mm 45 deg. 6mm 1.5mm 60 deg. 热流道转4点潜进胶，具体位置待模流分析确定 4 drops HRS, sub-gate, Gate location will finalize after mold flow study. 4 hot drops to cold runner sub-gate. Gate location to be finalized by Moldflow study. 0.8mm 1.5mm Φ5mm Φ6mm Φ5mm 热咀 注：走胶平衡要等模流分析后再调整。 Melt filing balance will finalize after mold flow study. Shoot balance to be adjusted/optimized