毕业论文-离合器总成的设计合编.docVIP

摘要 本文叙述了QX1040轻型载重汽车离合器总成的设计计算过程。介绍了离合器选型，对单片周置弹簧离合器的主要参数进行了设计计算，并基于Siemens NX软件对其零部件进行三维建模，详细描述了单片周置弹簧离合器的摩擦片和底盖的建模过程，并进行离合器摩擦片总成及压盘盖总成的装配，最后绘制主要零部件的二维工程图。 关键词：汽车离合器，设计计算，三维建模  Abstract This paper describes the QX1040 Light trucks design and calculation of the clutch assembly process. Introduces clutch type selection, choose single friction slices spiral spring clutch as design object. Designed and calculated the main parameters of the clutch. And three-dimensional modeling of its components based on Siemens NX software.A detailed description the process of building-up friction plate