车削理论-基础.ppt

* But to gain something from a 90° entering angle, your radial D.O.C must be bigger than the nose radius. If the DOC is not at least the nose radius then benefit of using a 90° entering is diminished and will tend to increase radial cutting forces (Vibration). * With the high stock removal rate the chips are needed to be evacuated out from the hole needs to be increased not to damage the work piece. Boring upside down to keep chips away from cutting edge？？？ * 演示--车削刀片断屑对比（见附件1） * Internal operations are to greater extent very sensitive to the ratio between the overhang and the diameter. It