[ESDS标识.docVIP

ESDS标识 两种理解： 理解1＝　安全数据表 理解２＝　静电放电 我倾向于理解为静电防护，　请从要求的上下文章来确认。　 来源９：　从百度文库，　下载IEC/TR 61340-5-2 请看第62,63, 64页 4.9.1 Marking of assemblies and equipment Marking of hardware items (assemblies and equipment) can be accomplished by using the symbol shown in Figure 12. Marking of hardware is dependent on space available on the item itself as well as the environment the item will operate in and whether marking will hinder the operation of the item. Some hardware labels might contain nomenclature along with the symbol in Figure 12. Wording such as, “ATTENTION, STATIC SENSITIVE DEVICES, Handle Only at Static Safe Workstations” or “ATTENTION – Sensitive Electronic Devices” may be included, depending on available space. An example of a warning label can be found in Figure 13. 4.9.2 Marking of packaging Marking of packaging materials, when ESD sensitive parts or assemblies are packaged inside (i.e. bags, pouches, fast packs, shipping containers, totes, etc.), can be accomplished by using the same symbol shown in Figure12. Typically, if multiple packaging materials are used for each ESDS item (i.e. wrap and pouch or fast pack), the outermost package should have the label on both sides and clearly visible to handling personnel. Packaging labels may also contain wording along with the symbol shown in Figure 13. In addition, it is strongly recommended that, where possible, the packaging be identified as ESD protective by using the label in Figure 14. 4.9.3 Other marking considerations Marking is sometimes used on other items that may be deemed a package, container or storage device by the organization. Items like storage cabinets or bins, shelving, and other items may be marked. The extent to which the organization wishes to mark hardware and packaging materials should be included in the organization’s ESD control program plan. Again, some contractual agreements may dictate marking requirements by an organization. ESD protective materials and equipment may also be marke