02m调频发射机的设计与制作--本科毕业设计.docVIP

本 科 生 毕 业 设 计 (论 文) 题目： 调频发射机 教学单位 __电气信息工程学院_ 姓 名 ___肖 睿_________ 学 号 __200931002152_____ 年 级 ____2009级________ 专 业 ___电子信息工程____ 指导教师 ___王一冰  目 录 摘要 2 Abstract 3 一、引言 4 二、发射机的原理分析与电路设计： 4 2.1系统框图： 4 2.2振荡器的设计： 5 2.2.1振荡器原理 5 2.2.2变容二极管部分接入调频 6 2.3稳压电源的设计 8 2.4谐振功放的设计 8 2.4.1：高频功放的简介 8 2.4.2谐振功放的工作原理： 9 2.4.3输出功率以及效率 11 2.4.4谐振功率放大器的动态特性 12 2.4.5谐振放大器电路的设计 15 2.5信号的发射 16 三、 试验数据的测量与分析 17 四、参考文献： 19 五、附录 20 5.1、系统总图 20 5.2 PCB TopLayer图 20 5.3 PCB BottomLayer图 21 5.4实物图 21 5.5元件清单 21 六、 致谢 22 摘要 调频发射机作为一种简单的通信工具，由于它不需要中转站和地面交换机站支持，就可以进行有效的移动通信，因此深受人们的欢迎。广泛的用于生产、保安、野外工程等领域的小范围移动通信工程中利用两级功率放大功率大大提高，经过滤波网络滤除高次谐波，最后通过拉杆天线发射出去。 FM transmitter as a simple communication tool, because it does not need to transfer station and the ground switch station support, can be effective mobile communication, therefore is popular among people. Convenient and widely used in the production, security, field engineering in areas such as small scale of mobile communication engineering. This time we mainly to design a frequency of 20 MHZ FM transmitter, FM was carried out on the input signal. First the input signal control varactor diode capacitance value size, for varactor part connected to the three-point capacitance frequency modulation, frequency modulation signal is produced. Frequency modulation signal of two-stage LC resonance power amplifier, power is greatly increased, the higher harmonic filtering through LC filter network, finally through the telescopic antenna. Using transformer coupling between level, then realize the impedance matching, and achieve the isolation level before and after, the transistor quiescent point are independent of each other. The oscillation magnitude using three-terminal voltage regulator chip to provide stable voltage, guarantee the stability of oscillator to produce frequency modulation signal. Key words: varactor diode, capacitor three-point, LC res