DW开关.pptVIP

DW开关 DW开关 一、型号 D W 10－600／3 二、结构 1、触头 1）主触头：通断主回路 2）弧触头：灭弧，保护主触头 3）辅助触头：控制指示灯及掉闸回路 特点：合闸时，弧触头先闭合，主触头后闭合，拉闸时顺序相反。 2．保护 1）短路保护：电磁线圈； 2）过载保护：电磁线圈；（1、1.5、3倍额定电流可调）； 3）失压、欠压保护：失压线圈 三、工作原理 四、掉闸方式 1、失压线圈：失电动作；（近控） 2、分励线圈：得电动作。（远控） 五、指示灯上电阻的作用 1、分压； 2、防止由于灯泡短路而造成电路误动作。 * * 断 万 设 额 极 路 能 计 定 数 器 式 序 电 号 流 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. L1 L2 L3 QS FU FV1 FV2 DW4 失压 R SB1 SB2 DW1 DW2 DW3 分励 绿灯 红灯 QF Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 1、合QS→绿灯亮(DW4)→负荷侧无电 2、合QF→DW4断开→绿灯灭 →DW3闭合→红灯亮→负荷侧有电 →DW2闭合→为FV2得电作准备 →DW1闭合→FV1得电→失压保护 3、按下SB1→FV1失电→失压保护动作→开 关掉闸 4、按下SB2→FV2得电→开关掉闸 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.