section323113-chain-linkfencesandgates.docVIP

This master should be used by designers working on Port of Portland construction projects and by designers working for PDX tenants (“Tenants”). Usage notes highlight a few specific editing choices, however the entire section should be evaluated and edited to fit specific project needs. SECTION 323113 - CHAIN-LINK FENCES AND GATES GENERAL DESCRIPTION This section describes the construction of new chainlink fence and gates. REFERENCES ASTM: American Society for Testing and Materials ASTM A121: Standard Specification for Metallic-Coated Carbon Steel Barbed Wire ASTM A123: Standard Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products ASTM A153: Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware ASTM A392: Standard Specification for Zinc-Coated Steel Chain-Link Fence Fabric ASTM F1043: Standard Specification for Strength and Protective Coatings on Steel Industrial Fence Framework ASTM F1083: Standard Specification for Pipe, Steel, Hot-Dipped Zinc-Coated (Galvanized) Welded, for Fence Structures ASTM F2329: Standard Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts, and Special Threaded Fasteners PRODUCTS GENERAL Galvanizing shall conform to the following specifications: Posts, rails, appurtenances  ASTM F1083, ASTM A121, ASTM A123, ASTM?A153, or ASTM F2329, as applicable. Fabric  ASTM A392, Class 1. SS40 materials shall conform to the following specifications: Posts, rails, and braces ASTM F1043, Group IC; external coatings per F1043, Type?B; internal coatings per F1043, Type D. Manufacturer shall be Allied Tube and Conduit, or equal. FABRIC Plain: Continuous chain-link, 2-inch-square mesh, 7?feet. Continuous chain-link, 2-inch-square mesh, width as shown on the drawings, for horizontal animal deterrent fence. 9-gauge carbon steel wire. Hot-dip galvanized at a rate of not less than 1.2 ounces of zinc per square foot of uncoated surface. Sel