ppt课件-2001-2005c230kompressoroilchangeprocedure-brianrichardson.pptVIP

2001-2005 C230 Kompressor Oil Change Procedure This only applies to 2001-2005 (I-4 supercharged engines) or w203 chassis. It might be the similar for other C-class models.Tools Needed:1. 27 mm socket or a crescent wrench2. Small flat head screwdriver3. Funnel4. 8mm socket *5. 1/2 inch socket *6. Lift Jack*7. Oil collection pan** Optional tools, only needed if you plan to drain the oil. If you suck the oil out these tools are not needed.Parts/Supplies Needed:1. Oil Filter (MB Part # A 271 180 00 09). My dealer provided a new drain plug washer the filter.2. Oil (Mobile One 0-40) C230 (I4 SC) needs 5.8-6.0 quarts.Procedure:1. Locate the oil filter and slightly loosen it, DO NOT remove it at this time. This will allow the oil in the filter to flow back to the oil pan. (See Photos 1 2 below)2. Jack up the car and remove plastic engine covers on the bottom of the car with 8mm socket.**3. Located oil pan drain plug and remove plug with 1/2 socket (See Photo 3 below) Make sure you have the oil collection pan under drain, because the oil will come flowing out fast.**4. As the oil is draining out, remove the oil filter from engine bay.5. Remove oil filter cartridge (this may take a little force) and three rubber o-rings. Replace oil filter cartridge and replace the three o-rings (See Photo 4 below) Coat the new o-rings with some new oil.6. Install drain plug with new washer and tighten to the proper torque spec (24N/m) or 1/2 turn past finger tight.7. Install oil filter into engine bay. DO NOT over tighten! Tight to the proper torque spec (24 N/m) or if you do NOT have a torque wrench tight a 1/4 turn past hand tight.8. Remove oil cap and input 5.25 quarts of oil using the funnel. (The reason why you should NOT add the entire 5.8 quarts is because there is still some residual oil in the engine and its not good to over fill. You can easily add oil, pain to take it out)9. After putting in 5.25 its, turn ignition key to position 2 (radio and heater/AC