specificationguide-rockwellautomation.docVIP

Specification Guide General The electronic overload relay shall be available in NEMA and IEC contactor mount configurations. The electronic overload relay shall be capable of being applied to single- and three-phase AC squirrel cage induction motors. For single-phase applications, only two phase connections to the electronic overload relay shall be required. The electronic overload relay shall have current ratings ranging from 0.4 to 5000 amperes. The FLA (full load ampere) setting adjustment range shall be a minimum of 5:1 (e.g. 9 - 45A). True RMS current measurement shall be accomplished with the use of hall-effect current sensors through 90 amperes; above 90 amperes, external torroid type current transformers may be used as input to the electronic overload relay. The electronic overload relay shall be capable of measuring current over a frequency range of 20 to 250 Hz. Supply voltage to the electronic overload relay shall be sourced from the 24V DC DeviceNet network supply. The internal power supply of the electronic overload relay shall provide reverse polarity protection, as well as limit the inrush current to less than 3A, to allow for multiple units to power up on DeviceNet simultaneously. A dedicated Trip relay with Form A contacts shall be provided for use in the motor starter control circuit. Trip relay operation shall be “fail-safe” such that the contacts are in the open state with supply voltage power removed. The electronic overload relay shall incorporate auxiliary relay outputs with Form A contacts that can be mapped for network use. Options shall exist for one or two outputs. All relay contacts shall be rated B300. The electronic overload relay shall incorporate 24V DC rated inputs that can be mapped for network use. Options shall exist for two or four inputs. 120V AC inputs shall be accommodated by an interface accessory. A Test/Reset button shall be provided on the front of the electronic overload relay for the dual purpose of testing relay