Step 的by step JNCIP.docVIP

Step by step IGP-OSPF : Activate protocol ospf area XX - edit protocol ospf area xx configure interface under protocol ospf - set interface fe-1/3/x.y or set interface ge-0/x/0.y (unit interface) or set interface lo0.xxx configure MD5 - set protocol ospf area x authentication-type md5 set protocol ospf area x interface xx-x/x/x authentication md5 1 key juniper configure RIP - set protocol rip neighbor fe-1/3/x.y or ge-0/x/0.y No LSA Type 4 and 5 - in router R1 and R6 - set area 1 stub default-metric 10 In router R1 and R6 - set area 1 interface fe-1/3/x.y or ge-0/x/0.y in router R3 and R4 - set area 2 nssa default-lsa default-metric 10 in router R3 and R4 - set area 2 interface fe-1/3/x.y or ge-0/x/0.y Redistribute RIP to OSPF - create policy in R3 and R4 edit policy-options policy-statement TO_OSPF term 1 set from protocol rip set from route-filter 55.55.55.0/24 orlonger set then accept put policy TO_OSPF into protocol RIP - set protocol ospf export TO_OSPF Redistribute OSPF to RIP - create policy in R3 and R4 Edit policy-options policy-statement TO_RIP term 1 Set from protocol rip Set from route-filter 0.0.0.0/0 exact Set then accept Set protocol rip group rip export TO_RIP Summarize all inter-area routes and RIP routes before going into backbone area - in R2 and R5 - set protocol ospf area 2 nssa area-range 55.55.55.0/24 Set protocol ospf area 2 area-range 10.0.8.0/24 Interface to T2 must seen as internal ospf route but must not send hello packets to that interface - set protocol ospf area 0 interface fe-1/3/x.y or ge-0/x/0 passive Step by step for IBGP + RR Create 2 Cluster and 4 RR in R2, R3, R4, R5 Set routing-option autonomous-system 65001 edit protocol BGP group cluster-x.x.x.x set type internal set local-address x.x.x.x (IP address loopback) set cluster x.x.x.x set neighbor x.x.x.x create iBGP between RR in R2, R3, R4, R5 edit protocol BGP group iBGP set type internal set local-address x.x.x.x (IP Address loopback) set neighbor x.x.x.x (ip loopback) cre