FX30青贮收割机应用解读.ppt

Operators course Zedelgem Harvester Training 五、竞争对手 六、工作效率 七、价格 790/900牵引青贮收获机 牵引青贮收获机竞争对手 1: Language, Metric / Imperial, engine speed and bargraph, Airco, Rotary brushes, Spout slow speed, Simultaneous movement flipper, User messages, High capacity hydraulics, screen contrast 2: Attachment width, semi auto HHC: ground level maximum position pressure just above ground level pressure just below maximum position 3: Ground speed tuning 4: Crop processor 5: Date time Enter E-value mode with ENTER and Ha Shaft turning - top value is rpm, (bottom value is calibrated max with engine) Shaft in rest - bottom value is E-value CPU Minimum trigger point: (no metal in front), (not 130) 149 (CPU 01/01/1996) 170 (CPU 01/01/1996) CPU maximum trigger point (metal in front) 200 (all) Blower is not used Knives: Grass: Busatis #: Lund #:(Better) Corn: Busatis #:Shearbar: Grass: Busatis #: Lund #:(Better) parts only Corn: Busatis #: Busatis #:(heavy duty) parts only Stone: Grass: Bay State #:(for Busatis) Bay State #:(for Lund, grey) Corn: Bay State #: The attachment is clamped on by a tierod with 2 nuts. An hydrostatic pump drives the attachment drive gearbox on the left hand side of the Chopperbody. The length of cut is variable between 4 and 10 mm in the low range and between 8 and 20 mm in the high. The selection between high and low is made on the HydroLOC gearbox on the right hand side of the Chopperbody. On the attachment drive gearbox are 2 output shafts:1. 300-750 rpm for the pick-ups, 300N6 corn head and the snapper headers2. 500-1260 rpm for the RI corn headers and DC510 The hydrostatic motor is blocked by a stop valve after a metal detection.  When the lever on the HydroLOC gearbox is push to the inside the low range is selected. When it is pulled to the outside the high range is selected. The Decal s