a practical guideto‘ free- energy’ devices（一个实际guideto自由能量的设备）.docVIP

A Practical Guide to Free-Energy Devices Author: Patrick J. Kelly Chapter 2: Moving Pulsed Systems Note: If you are not at all familiar with basic electronics, you might find it easier to understand this chapter if you read chapter 12 first. There are three categories of pulsed system and we will consider each in turn. These are drive-pulsed systems, energy-tapping pulsed systems and gravity free-energy pulsing systems. Here we will look at systems where an electrical pulse is used to cause the device to operate by creating a temporary magnetic field caused by electric current flowing through a coil or “electromagnet” as it is often called. Many of these systems are rather subtle in the way that they operate. One very well-known example of this is The Motor/Generator of Robert Adams. The late Robert Adams, an electrical engineer of New Zealand designed and built several varieties of electric motor using permanent magnets on the rotor and pulsed electromagnets on the frame of the motor (called the stator because it does not move). He found that if they were configured correctly, then the output from his motors exceeded their input power by a large margin (800%). The diagram of his motor intended to show the basic operating principle is shown here: If a motor is built like this, then it will most certainly work but it will never reach 100% efficiency let alone exceeding the 100% mark. It is only with a specific configuration which is hardly ever publicised that high performance figures can be achieved. While Robert has shown several different configurations, in order to avoid confusion I will describe and explain just one of them. I am indebted to several of Roberts friends and colleagues for the following information and I should like to express my thanks to them for their help and support in bringing you this information. First and foremost