高速多轴加工经典举例解析.pptVIP

* * * * * * * * * * 狭槽的5轴加工5-Axis Machining of Slots 3轴加工球刀清角时会留下圆角，必须手动加刀路清出直角 Using 3-axis machining will leave a fillet in the corners. The corner must then be finished by hand 5轴加工则可用平底刀清出利角，无需在再后续电极清角 Using 5-axis machining with an end-mill leaves a sharp corner, needing minimal hand finishing 不用后续电极清角就意味着节省时间提高加工质量 The reduction in hand finishing saves time and improves quality Swarf加工Swarf Machining Swarf加工使用刀具侧刃切削Swarf Machining cuts with the side of the tool 由于切削刀具是直刃，所以只能加工可展开的曲面（直纹面）It can only be used with developable surfaces as cutter side is straight 切削的深度可