IBM刀片内置博科光纤交换机连接cisco光纤交换机时链路问题处理.docVIP

将IBM刀片上内置的博科交换机用多模光纤连接到cisco9134交换机19上时，端口灯状态是正常的，但在cisco上查看端口状态时一直都是down的（fc1/19 is down (Isolation due to zone merge failure) 从刀片到cisco的光纤链路实际上是不通的，以下是解决链路畅通的方法： telnet登录博科交换机，查看firmware版本信息 brocade4Gb:USERID version Kernel: 2.6.14.2 Fabric OS: v6.1.1d Made on: Tue Jan 20 18:29:20 2009 Flash: Thu Nov 5 04:48:47 2009 BootProm: 4.6.6 更改博科交换机的模式AG（Access Gateway）模式 brocade4Gb:USERID switchdisable （关闭全局端口交换） brocade4Gb:USERID ag --modeenable （更改为AG模式） WARNING: Access Gateway mode changes the standard behavior of the switch. Please check Access Gateway Administrators Guide before proceeding. Enabling agmode will remove all the configuration data on the switch including zoning configuration and security database. Please backup your configuration using configupload. This operation will reboot the switch. Do you want to continue? (yes, y, no, n): [no] y Access Gateway mode was enabled successfully Switch is being rebooted... 查看博科交换机端口license并激活要连接到cisco交换机的端口 brocade4Gb:USERID licenseport --show 20 ports are available in this switch No POD licenses are installed Dynamic POD method is in use 10 port assignments are provisioned for use in this switch: 10 port assignments are provisioned by the base switch license * 5 port assignments are added if the first POD license is installed * 5 more assignments are added if the second POD license is installed 9 ports are assigned to installed licenses: 9 ports are assigned to the base switch license Ports assigned to the base switch license: 0*, 1*, 2*, 3*, 4*, 5*, 6*, 15*, 16* Ports assigned to the first POD license: None Ports assigned to the second POD license: None Ports not assigned to a license: 7, 8, 9, 10, 11, 12, 13, 14, 17, 18, 19 1 license reservation is still available for use by unassigned ports 9 license assignments are held by offline ports (indicated by *) brocade4Gb:USERID portenable 15（使用博科的15口与cisco9134的19口连接） （