原创力文档- 1、本文档共6页，可阅读全部内容。
- 2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
- 3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
查看更多
Production installation of cable terminals and connectors
7.8.5.2.1 construction preparation
7.8.5.2.1.1 technical preparation
(1) check the cable accessory parts and materials should be installed with the cable.
(2) check the installation tools, should be complete, intact.
(3) is installed between cable accessories should be to test whether the cable be affected with damp be affected with damp, if damaged, inspection method is as follows: with shaking table test each phase of the cable core insulation resistance, 1 kv and below cable should be no less than 100 m Ω, 6 kv and above cable should be no less than 200 m Ω. Or do dc leakage current withstand voltage test.
7.8.5.2.1.2 operation conditions
(1) has a wide operation site, construction site clean, and equipped with 220 v ac power.
(2) in the workplaces where environmental temperature above 0 ℃, relative humidity below 70%, it is strictly prohibited in the rain, snow, wind weather construction.
(3) aerial work should build a good platform, over the construction site set up tents, prevent dust intrusion.
(4) transformer, high and low voltage switchgear, cables are installed, cable insulation.
7.8.5.2.2 construction technology
(1) the dry bag type crosslinked xlpe power cable terminal head of production process.
1) equipment point check: material is in line with the number on the packing list, the postal inspection appearance presence of abnormal phenomenon, according to the sequence of operation is put in the big plate.
2) the insulation of the cable telemetry: open the cable seal, with 2500 v shake table test qualified rear can into the next process.
3) the stripping cable sheath.
A. shell outer sheath: use clamp to fix cable vertical, measuring 750 mm to the cable port (indoor head measuring 550 mm), remove outer sheath.
B. peel armoring: from outer sheath fracture measuring 30 mm armoring, tighten with a lead wire, the rest of the strip.
C. peel inside cushion: from the amount of armoured fracture within 20 m
文档评论（0）