第三章扫描放样特征.pptVIP

华南农业大学工程学院 刘天湖 Chapter 3第三部分 扫描特征、放样特征 * Learning Objectives Chapter 3 创建扫描特征. 创建放样特征 高级建模工具 Some of the advanced modeling tools were discussed in earlier chapters. The remaining advanced modeling tools are discussed in this chapter. 创建扫描特征 图A是用于扫描的草图. 图B是扫描生成的特征. Choose the Sweep button from the Features CommandManager to invoke the Sweep PropertyManager, as shown in Figure C. Figure C The Sweep PropertyManager Figure A Sketches to create a sweep feature Figure B Sweep feature Chapter 3 链接 图D是没有相交的截面形状和路径。 图E是扫描结果. Figure F shows the sketch of the profile and the closed path. Figure G shows the resulting sweep feature. Figure D Non-intersecting sketches of profile and path Figure E Resulting Sweep feature Figure G Resulting Sweep feature Figure F Sketch of the profile and the closed path Chapter 3 链接 链接 扫描属性对话框中的可选项有: 方向/扭曲控制选项 Sketches for the sweep feature Sweep feature with the Keep normal constant option selected from the Orientation/Twist Type drop-down list Sweep feature with the Follow Path option selected from the Orientation/Twist Type drop-down list Chapter 3 链接 Show Preview Merge Results 保持相切 Advanced Smoothing Align with End Faces Resultant sweep feature with the Align with end faces check box cleared Sketches for the sweep feature Resultant sweep feature with the Align with end faces check box selected Chapter 3 链接 应用扭曲选项 While creating a sweep feature, you can also apply twist to it by choosing the Twist Along Path option from the Orientation/twist type drop-down list. The Defined by drop-down list and the Twist Angle spinner is displayed below the Orientation/twist type drop-down list, as shown in Figure A. Figure A The Options rollout Chapter 3 You can also apply a twist to the swept feature keeping its end face parallel to the profile and the entire transition normal to the sweep path. To apply this type of twist, choose the Twist Along Path With Normal Constant option from the Orientation/twist type drop-