PLC动力配电柜设计 【毕业论文+CAD图纸全套】.doc

PLC动力配电柜设计 摘 要 本次毕业设计主要是针对“动力配电柜设计”的要求，在满足各种参数要求的前提下，拿出一个具体实际可行的方案，因此从实际出发，认真的思考与筛选，经过两个多月的努力终于有了现在的收获。 按照设计的具体要求，把设计的重点放在电动机的启动方式、过载保护、短路保护、缺相保护等，并且能异地控制。电器元件安装排列有序，导线及母线安排的布置符合各自的工艺要求。还有柜体满足使用功能及工艺要求。 经过控制方案的分析确定了自耦变压器减压启动。为了保证电力拖动控制系统中电动机、各种电器和控制电路的正常运行，消除可能出现的危险因素，并在出现电器故障时进可能的缩小故障范围，对电力拖动控制系统设置各种连锁和保护环节。与对应的主电路要考虑到有关保护外，还要对主电路的电流大小应有指示。根据控制要求和主电路的设计方案设计控制电路。柜体的满足尺寸要求、功能要求和工艺要求。从总体上选择元气件，导线等。 关键词：可编程序控制器， 自耦变压器， 电气布置图， 配电柜 LC POWER DISTRIBUTION ARK DESIGN ABSTRACT The graduation design is mainly aimed at power distribution ark design requirement, in various parameters, under the premise of take out a specific practical feasible scheme, so we from reality, serious thinking and selecting, after more than two months to finally have the right now. According to the specific requirements of the design, we focus on the design of the motor start-up manner and overload protection, short circuit protection, phase, and different control. The electrical components installed orderly, wire and the layout accord with their respective bulbar arrangement of the technological requirements. Still meet the cabinet put oneself in anothers position and the requirement of technology function. Through the analysis of the control scheme determined the transformer decompression. In order to guarantee the electrical towage control system, various electric motor and control circuit of normal operation, eliminate possible risk factors, and electrical breakdown into the narrow scope of fault may drag on electric control system, various chain and protection setting. The main circuit with corresponding to consider the protection of the relevant to the main circuit, the current size should be instructions. According to the requirements of the main circuit and control circuit design scheme design control. The cabinet put oneself in anothers position; function request meets size and technical requirements. From the overall selection, wire etc e