ADAMS的全面详细教程.ppt

* 螺旋副不能单独使用，要与圆柱副同时使用。 例子见Screw.bin * 万向节（ Universal Joint ）：两回转轴通过十字轴中心， 胡克节（ Hooke Joint ）：两回转轴通过其定位点。 * 例子见：C:\Documents and Settings\lcq\Gear3.bin C:\Documents and Settings\lcq\GearRack.bin 齿轮齿条 * 三个零件关联的计算公式待考。 * 例子见C:\Documents and Settings\lcq\ouplerSampl1.bin 当q为转角时，单位为弧度。 * 运动力： 1. 当用1 Location时： 当施加运动方向的合力为零时，施加常速相当施加一个冲量，产生一个相应的动量。 当施加运动方向的合力不为零时，施加常速相当施加一个常力与之平衡，再给一初始条件：给定速度。 此冲量或力由外界提供。 2. 当用2 Bodies – 1 Location 施加运动时，冲量或力就作用在两物体之间。 * * 预载时长度：输入预载长度。 缺省长度：设计时的弹簧长度作为预载长度。 * The marker on the action body, the first part you select, is the I marker. The marker on the reaction body, the second part you select, is the J marker. The forces the beam produces are linearly dependent on the relative displacements and velocities of the markers at the beam’s endpoints. The x-axis of the J marker defines the centroidal axis of the beam. The y-axis and z-axis of the J marker are the principal axes of the cross section. They are perpendicular to the x-axis and to each other. When the beam is in an undeflected position, the I marker has the same angular orientation as the J marker, and the I marker lies on the x-axis of the J marker. ADAMS/View applies the following forces in response to the translational and the rotational deflections of the I marker with respect to the J marker: Axial forces (s1 and s7) Bending moments about the y-axis and z-axis (s5, s6, s11, and s12) Twisting moments about the x-axis (s4 and s10) Shear forces (s2, s3, s8, and s9) Note: You can use a field element instead of a beam to define a beam with characteristics unlike those that the beam assumes. For example, a field element can define a beam with a non-uniform cross section or a beam with nonlinear material characteristics. * Fx, Fy, and Fz are the measure numbers of the translational force components in the coordinate system of the J marker. x, y, and z are the translational displacements of the I marker with respect to the J marker measured in the coo