Basics建模要件.docx

Basics建模要件STREAMS汽2 Passive Types (Type 0 and Type 6)- 2 被动型 (类型 0 和类型 6)水流动* Pressure Drop*压降HEAT EXCHANGERS热交换器GENERAL HEAT EXCHANGER WITH SPECIFIED SHELL AND TUBE INLET STREAMS带有特定壳侧和管侧进口汽水流动的通用热交换器REHEATER再热器GENERAL HEAT EXCHANGER WITH SPECIFIED HEAT SOURCE OR SINK带有特定放热源和吸热源的通用热交换器Stream Type 4 Inlet类型4汽水流动的进口Nuclear Reheater (Type 22) “S” Port核电再热器（类型22）“S” 端口INPUT输入Input Data输入数据Generic Input (optional unless otherwise noted)通用输入（除非另行说明，均可选）Cycle Flags (required, but input is default)循环标识（必选，输入是默认的）Output Tables输出表格Screen Display Variables屏幕显示的变量Calculation Flags计算标识User Specified Material Properties用户指定的物质属性2nd Law Reference Data热力学第二定律参考数据End Notes结束说明Input ProcessoSets and Cases设置和事例r*输入处理器*Run 2 cases using the data from Sets 1 and 2 for the first case, and Sets 1-4 for the second case.运行两个案例：第一个案例使用设置1和2中的数据，第二个案例使用设置1-4中的数据SCHEDULED VARIABLE VALUES CALCULATED (All Special Features Calculated)计算预定变量值（计算所有特殊功能）FLAG SETTINGS AND DATA FOR SYSTEM系统标识旗的设置和数据Short Cuts!快捷方式!Operational Variables运算Operations (Equations)操作（方程）变量Input/Output Processor输入/输出处理器Input/Output Values Must be Dependent输入/输出值必须是有函数关系的Operational Variables操作变量specifies 输入IWWMass flow (lbm/hr, kg/sec)IWW 质量流量(lbm/hr, kg/sec)IHCHeat Transfer Coefficient IHC传热系数IBSpressure drop equation B coefficient IBS压降方程式B系数（参见帮助）Uses Special Output Processor to Export Data and Results使用特殊输出处理器输出数据和结果。specifies 规定Conservation of Mass质量守恒All Inlet Ports Must be Resolved所有进口端口必须均已确定。Turbine, Types 1–7汽轮机Heat Exchangers, Types 20-23, 28-29热交换器，类型20-23, 28-29，类型1-7Flag Design Mode in Input (or Choose Design Mode Component Type)输入中使用标识设计模式（Flag Design Mode）或选择设计模式部件类型（Design Mode Component Type）。Tube out Shell exit port superheat管道出口（壳侧出口以标准为基础的预测Ref-BasedPredictiveUse of Overall Heat Transfer Coefficients总体换热系数的使用Components in Design Mode设计模式中的部件Condenser Sensitivity Study凝汽器灵敏度以标准为基础的预测Boiler Operating Parameter Study锅炉运行参数分析STREAMS汽水流动Fluid Passes Through Unchanged* 流体流动时状态恒定* Pressure Drop*压降* Heat Lo