汽车电器培训 ETACS及BCM（中）培训.pptVIP

喷水雨刷控制 喷水雨刷电路 车速联动间歇雨刷控制 车速联动间歇雨刷控制电路 后风挡除雾 后风挡除雾电路 安全带警报 安全带警报 减光式室内灯 无钥匙解锁控制 钥匙筒照明 警戒功能 解除警戒功能 警报功能 警报状态1 9.1密码存储方式“1” – Non Immobilizer 防止启动电路2 Memory Switch OFF SET TX Signal TX Signal TX Signal Ⅲ Received signal EFFICIENCY EFFICIENCY EFFICIENCY EFFICIENCY NORMAL STATE FRAME FRAME FRAME FRAME FRAME FRAME FRAME SETUP STATE SETUP STATE FRAME 9. 发射器信号存储 1. 从钥匙孔拔出点火钥匙 2.把 “OFF/SET” 开关拨到 “SET”位置。 OFF/SET 开关起先在 “OFF” 位置。 3.按下发射器“Lock” 或” Unlock” 按钮 如果 “Lock or Unlock” 按钮同时按下，lock信号优先 4.把 “OFF/SET” 开关再次拨到 “OFF” 位置。 OFF SET OFF SET OFF SET OFF/SET SW Receive Antenna 1 2 3 XD ETACSCM OFF SET ? ※Off/Set switch located on ICM. 2.把 “OFF/SET” 开关拨到 “SET”位置的同时按下发射器上的 “Lock Unlock” 按钮 and Lock or Unlock push once again. ? OFF/SET 开关起先在 “OFF” 位置。 OFF SET 2 OFF SET 4 4.把 “OFF/SET” 开关再次拨到 “OFF” 位置 1. 点火开关“ON”并且等待5秒以上 1 Off/Set switch ICM Antenna ※ ICM : Immobilizer Control Module Off Set 9.2 密码存储方式 “2” – Immobilizer  用 Hi-scan存储钥匙码 无钥匙进入码的存储 1.按发射器 [上锁] 键1秒以上. 2. 如果需要存储一个以上，按另一个发射器 [上锁] 键1秒以上 3.关闭HISCAN, 试验遥控系统. OFF/SET SW Position OFF SET OFF ON(Push) OFF ON(PUSH) Transmitter”1” Look Pushed 1sec. 1st TX Pushed Look Button 2nd TX Pushed UNLOCK Button 1sec. Transmitter”2” Look Pushed 存储钥匙密码的各种情况 1. 2EA 发射器存码情况1 OFF/SET SW Position OFF SET OFF ON(Push) OFF ON(PUSH) Transmitter”1” Lock Pushed 1sec. 1st TX Pushed Lock Button(used TX) 2nd TX Pushed Unlock Button(brand new TX) 1sec. Transmitter”2” Unlock Pushed 发射器存码情况2 After one more purchasing in one key use. 1. 2EA 发射器存储密码情况 OFF/SET SW Position OFF SET OFF ON(Push) OFF ON(PUSH) Transmitter”1” Lock Pushed 1sec. 1st TX Pushed Lock Button(used TX) 2nd TX Pushed Unlock Button(brand new TX) 1sec. Transmitter”2” Unlock Pushed 发射器存码情况3 Newly usage after losing one key in two keys use. The first key that is registered remote code must not use and the second and third one is possible to use only, if two pieces of remote keys are registered and registered one mo