Unit4ThePerformanceofSecondOrderSystem.ppt

Unit 4 The Performance of Second Order System 中華技術學院電子系 副教授 蔡樸生 副教授 林盈灝 Open Loop Close Loop The Performance of Second Order System The Response of Second Order System Homework 1 The Response of Homework2 : The effect of damping ratio P Controller This type of control action is formally known as proportional control (Gain) Homework3 : K=1, K=4 , K=8 , K=12 , K=36 Please explain the effect of P controller to the second order system PD Controller The Performance of P Controller : The error signal is positive, the torque is positive and rising rapidly. The large overshoot and oscillations in the output because lack of damping. : The error signal is negative, the torque is negative and slow down causes the direction of the output to reverse and undershoot. : The torque is again positive, thus tending to reduce the undershoot, the error amplitude is reduced with each oscillations. The contributing factors to the high overshoot The positive correcting torque in the interval is too large (抑制) Decrease the amount of positive torque The retarding torque in the interval is inadequate (增強) Increase the retarding torque The Effect of PD Controller : is negative; this will reduce the original torque due to alone. : both and is negative; the negative retarding torque will be greater than that with only P controller. : and have opposite signs. Thus the negative torque that originally contributes to the undershoot is reduced also. Homework 4 Solution of PD Controller clear; x1=0;x2=0;dt=0.01;r=1;step=2000; kp=36;kd=6;pe=r-x1; for k=1:step t(k)=k*dt; e=r-x1; de=(e-pe)/dt; u=kp*e+kd*de; x1=x2*dt+x1; x2=(u-4*x2)*dt+x2; pos(k)=x1;vel(k)=x2;pe=e; end PI Controller HW5 : The Effect of PI Controller Adds a zero at to the forward-p