Workbench Simulation Emag工作台仿真埃马克.pptVIP

July 30, 1999 Solid Conductor Chapter 6 WS05: Solid Conductor Workshop #5: Solid Conductor A DC energized coil is wrapped around a permeable C core. The geometry of the core and coil are available on a parasolids file and are imported into Workbench. The geometry is cut in half and the resulting half symmetry model is solved. The current distribution in conductors modeled in this manner is that of a DC energized solid conductor (NOT uniform over the cross section as with stranded conductors and NOT subject to redistribution due to the skin effect). Although the current distribution is that of a single turn solid conductor, the number of turns specified for such conductors may be greater than one. Error introduced by approximating stranded coils in this manner is usually acceptable for most applications. WS05: Solid Conductor Import parasolids geometry on file magnet_assem.x_t. WS05: Solid Conductor Create a spherical enclosure with a 225 mm cushion. Ensure that the “Merge Parts?” value is set to “Yes”. WS05: Solid Conductor We wish to create a half symmetry model. In order to cut the imported geometry, it must first be “frozen”. WS05: Solid Conductor Create a slice plane. Select the global ZXPlane to be the base plane of the slice. WS05: Solid Conductor Hold the Ctrl button down and use the LMB to select the 3 parts labeled “Solid” in the tree. The RMB will produce the drop down menu shown at right. Select “Suppress Body” to eliminate upper portions of the geometry from further consideration. WS05: Solid Conductor Save the design modeler geometry and click on the Project tab. Select “New Simulation”. Choose Emag Branch in the simulation wizard to help guide you through the simulation process. WS05: Solid Conductor Select “Magnet” in the tree and import SA1010 steel material properties to be associated with it. Select “Coil” in the tree and import “Copper Alloy”. WS05: Solid Conductor Graphically select the core and right click on Mesh in the tree to assign