基准预同步的逆变器并联运行均流控制研究.pdfVIP

电力电子与电力传动 ·1101 · 基准预同步的逆变器并联运行均流控制研究 何中一 邢 岩 祁飚杰 南京航空航天大学航空电源航空科技重点实验室 江苏 南京 210016 【摘 要】 针对传统的无连线逆变器下垂并联方法和传统的有连线分布式并联方法的缺点，提出了一 种电压基准预同步的逆变器并联系统输出均流控制方法，首先研究并实现基于电力线通信 （PLC ）的电压基准信号的同步控制 ，在基准同步先行的基础上，利用 PLC 或 CAN 通信在 各并联逆变器之间传递有功功率、无功功率信息并生成功率差信号，根据功率差相应调节 电压基准信号的相位和幅度，研究了能够实现负载均分的功率调节累加算法，实现了输出 均流和并联模块的热插拔。仿真分析和实验结果证实了控制策略的有效性和可行性。 【关键词】 逆变器 并联 同步 均流 电力线通信 控制器区域网 Research on Current Sharing Control for Inverter Parallel System Based on Pre-synchronized Voltage Reference Signals He Zhongyi ，Xing Yan ，Qi Biaojie Nanjing University of Aeronautics and Astronautics ，Nanjing 210016 ，Jiangsu ，China Abstract ：A novel output current sharing control for multi-inverter system based on pre- synchronized voltage reference signal is proposed to take advantage of both the conventional wireless droop method and the distribution control method with analog current sharing bus. The pre-synchronization control for voltage reference signal is implemented by combining power line communication （PLC ） and digital signal processor （DSP ） hardware with the corresponding software algorithm. Unlike the conventional droop method ，the phase and amplitude of the voltage reference signals are regulated by the output power differences between the output power of each inverter and the average load power ，and the output power differences are generated by implementing communication such as PLC and controller area network （CAN ） among the parallel inver