配置VOIP与PSTN相互直拔流程-asterisk[freePBX]linksysspa3000.docVIP

配置VOIP与PSTN相互直拔流程-asterisk(freePBX)+linksys spa3000 原文在此：/2006/10/15/configuring-sipura-spa-3000-as-trunk-within-asterisk-voip-pbx-server/ 我来补充实际截图吧。  Configuring Trunk within Asterisk PBX using AMP Login to AMP (Asterisk Management Portal). Navigate to Setup, Trunks, and choose “Add SIP Trunk”. General Settings  1.Outbound Caller ID: (leave blank - cannot be used by POTS line) 2.Maximum Channels: 1 (required - see note below) NOTE: Each SPA-3000 supports a single channel. You need to setup multiple trunks for multiple SPA-3000 devices. Outgoing Dial Rules Dial Rules: 1NXXXXXXXXX ; prefix 10 digit dialing with 1 这里是指1开头的11位手机号 [23468]XXXXXXX ; 本地的市话，一般是以23468开头的8位  Outgoing Settings  Trunk Name: pstn_spa01  Peer Details: auth=md5 context=from-pstn dtmfmode=inband fromuser=asterisk host=1 ; IP address of SPA device insecure=very nat=yes ; omit if no NAT exists between PBX and SPA port=5061 secret=012345678901 type=peer username=asterisk Incoming Settings  User Context: spa01  User Details: allow=ulaw context=from-pstn disallow=all dtmfmode=inband host=1 ; IP address of SPA device insecure=very nat=yes ; omit if no NAT exists between PBX and SPA secret=KzBTALezmG1a type=friend Registration 1.Register String: ; omit - not necessary to register w/ SPA device? 这个我是留空了  Configuring Outbound Routing within Asterisk PBX using AMP Login to AMP (Asterisk Management Portal). Navigate to Setup, Outbound Routing, and choose “Add Route”. Add Route Route Name: pstnspa1 ; user preference, avoid special characters here? Dial Patterns: ; dial 5 plus 11 digit, 10 digit, and 7 digit numbers ; omit each 5| to use trunk without dialing prefix 5|1NXXNXXXXXX ; accept 5 + 11 digit dialing 5|NXXNXXXXXX ; accept 5 + 10 digit dialing 5|NXXXXXX ; accept 5 + 7 digit dialing俺家的总机外拔要加9...  Trunk Sequence: ; add each available SPA-3000 trunk SIP/pstn