模具磨損小、壽命長、加工精度高、H-FRAMELink震動小、噪音低.pdfVIP

LMP SERIES Minimize Tool Wear to Increase Die Life. Get Tight Tolerance and High Dimensional Accuracy. Reduce Shock and Vibration to Result in Low Noise. C-FRAME Link Motion Press C I 229033 I 244428 Patents: (R.O.C.) No. I 229033 (R.O.C.) No. I 244428 H-FRAME Link Motion Press H Note/ SPM can be increased by shortening Stroke Length on custom-made basis. Stroke Length SPM LMP-110-H 50 mm 30-150 SPM Machinery is the key to industrial manufacturing SPECIFICATIONS Mode Type Max. Capactity Tonnage Rating Point SPM Stroke Length Die Height Slide Adjustment Area of Slide (L-RxF-B) Area of Bolster (L-RxF-B) Thickness of Bolster Main Electric Motor Slide Adjustment Motor UNIT TONS MM SPM MM MM MM (L-RxF-B) MM x MM (L-RxF-B) MM x MM MM HP x P HP x P LMP-80-C BD 80 80 55 30-80 30-55 100 160 300 330 80 80 560 x 420 560 x 420 1000 x 500 1000 x 500 100 100 7.5 x 4 7.5 x 4 0.2 x 4 0.2 x 4 ADVANTAGES LMP-110-C BD 110 110 55 30-70 30-50 120 180 320 350 90 90 650 x 500 650 x 500 1020 x 560 1020 x 560 120 120 10 x 4 10 x 4 0.2 x 4 0.2 x 4 LMP-160-C BD 160 160 66 30-60 30-45 130 200 350 400 100 100 700 x 520 700 x 520 1200 x 650 1200 x 650 150 150 15 x 4 15 x 4 0.5 x 4 0.5 x 4 LMP-200-C BD 200 200 66 30-50 30-40 150 200 410 450 110 110 850 x 590 850 x 590 1350 x 700 1350 x 700 170 170 20 x 4 20 x 4 0.75 x 4 0.75 x 4 D Type Drawing Type For Drawing and Deeper Forming MOTION DIAGRAM LMP-110(D-Type) mm 0 90 Stroke 180 0o 90o 180o Main Gear Angle Long Jyi’s D-Type Link Motion Press. Crank Motion Press. D-Type 09 270o Width of red part means slide velocity Accelerated approach/ return speed To reclaim the lost time created by the slide velocity reduction in the lower portion of the press stroke, the velocity is increased through the upper portion of the stroke so that strokes per minute are not sacrificed. Increasing dwell time at lower speed at stroke bottom for portion drawing veloctity to 360o avoid material may tear, wrinkle and crack to get less burrs and high quality stamped parts.