酒坛画法9.docVIP

酒坛 酒坛外框 用PLINE、LINE命令创建。 Command: _pline Specify start point: Current line-width is 0.0000 Specify next point or [Arc/Halfwidth/Length/Undo/Width]: W Specify starting width 0.0000: 0.3 Specify ending width 0.3000: Specify next point or [Arc/Halfwidth/Length/Undo/Width]: @100,0 Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: A Specify endpoint of arc or [Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: @0,-30 Specify endpoint of arc or [Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: @0,-30 Specify endpoint of arc or [Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: @40,-40 Specify endpoint of arc or [Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: @-40,-80 Specify endpoint of arc or [Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second pt/Undo/Width]: L Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: @-100,0 Specify next point or [Arc/Close/Halfwidth/Length/Undo/Width]: 2．偏移多段线 Command: _explode 1 found（多段线） Command: _pedit Select polyline or [Multiple]:EF Object selected is not a polyline Do you want to turn it into one? Y Enter an option [Close/Join/Width/Edit vertex/Fit/Spline/Decurve/Ltype gen/Undo]: J Select objects: 1 found GF Select objects: 1 found, 2 total EF Select objects: 1 found, 3 total DE Select objects: 2 segments added to polyline Enter an option [Close/Join/Width/Edit vertex/Fit/Spline/Decurve/Ltype gen/Undo]: Command: _offset Current settings: Erase source=No Layer=Source OFFSETGAPTYPE=0 Specify offset distance or [Through/Erase/Layer] Through: 10 Select object to offset or [Exit/Undo] Exit: DEFG Specify point on side to offset or [Exit/Multiple/Undo] Exit: 内侧 Select object to offset or [Exit/Undo] Exit: CD Specify point on side to offset or [Exit/Multiple/Undo] Exit: 内侧 Select object to offset or [Exit/Undo] Exit: 3．酒坛轮廓 用BREAK、LINE等命令绘制如下所示酒坛轮廓。 合并除AG以外的所有线段。 4．完成绘制 Command: surf