L2TP协议原理与应用（二）-高志岩.pptVIP

实验拓扑 接口及路由配置 * 双LNS接入 R4的配置 interface FastEthernet0/0.9 encapsulation dot1Q 9 ip address vrrp 9 ip vrrp 9 priority 150 vrrp 9 track 50 ! interface FastEthernet0/0.10 encapsulation dot1Q 10 ip address vrrp 10 ip vrrp 10 priority 150 vrrp 10 track 50 ip route R5的配置 interface FastEthernet0/0.9 encapsulation dot1Q 9 ip address vrrp 9 ip vrrp 9 priority 120 ! interface FastEthernet0/0.10 encapsulation dot1Q 10 ip address vrrp 10 ip vrrp 10 priority 120 ip route 实验拓扑 Client的PPP拨号配置 * 双LNS接入 R1的配置 interface Serial1/0 ip address negotiated encapsulation ppp ppp chap hostname r1@ ppp chap password 0 r1 ip route Serial1/0 LAC（R2）上对应接口配置 interface Serial1/0 no ip address encapsulation ppp ppp authentication chap 实验拓扑 LAC上的L2TP配置 * 双LNS接入 R2的配置 vpdn enable ! vpdn-group 1 request-dialin protocol l2tp domain initiate-to ip no l2tp tunnel authentication LAC与LNS外网口的VRRP虚地址建立L2TP隧道 实验拓扑 LNS上的L2TP配置 * 双LNS接入 R4的配置 vpdn enable vpdn-group 1 ! Default L2TP VPDN group accept-dialin protocol l2tp virtual-template 1 source-ip no l2tp tunnel authentication ! username r1@ password 0 r1 interface Loopback0 ip address 55interface Virtual-Template1 ip unnumbered Loopback0 peer default ip address pool POOL ppp authentication chap ! ip local pool POOL 0 R5的配置 vpdn enable vpdn-group 1 ! Default L2TP VPDN group accept-dialin protocol l2tp virtual-template 1 source-ip no l2tp tunnel authentication ! username r1@ password 0 r1 interface Loopback0 ip address 55interface Virtual-Template1 ip unnumbered Loopback0 peer default ip address pool POOL ppp authentication chap ! ip local pool POOL 0 实验拓扑 结果验证 * 双LNS接入 r2#sh vpdn L2TP Tunnel and Session Information Total tunnels 1 sessions 1 LocID RemID Remote Name State Remote Address Port Sessions VPDN Group 13444 46936 r4 est 1701 1 1 LocID RemID TunID Intf Username