Router basic configure.pptVIP

Objectives Upon completing this lesson, you will be able to: Use the CLI to interact with the Cisco IOS software, given an operational router Verify the default configuration of the device, given a functioning router Complete the initial device configuration, given a functioning router Configure IP addresses and IP subnet masks on router interfaces, given a functioning router Overview of Router Modes Saving Configurations Configuring Router Identification Configuring a Router Password Other Console-Line Commands Configuring an Interface Configuring a Serial Interface Enter Global Configuration Mode Ethernet media-type Command Disabling or Enabling an Interface Introducing IP Addresses Unique addressing allows communication between end stations. Path choice is based on destination address. Location is represented by an address IP Addressing IP Address Classes Host Addresses Addressing Without Subnets Addressing with Subnets Subnet Addressing Subnet Mask Decimal Equivalents of Bit Patterns Subnet Mask Without Subnets Subnets not in use—the default Subnet Mask with Subnets Network number extended by eight bits Subnet Mask with Subnets (Cont.) Network number extended by ten bits Configuring the Router IP Address Router show interfaces Command Interpreting the Interface Status Verifying a Serial Interface Configuration Serial Interface show controller Command Summary From the privileged EXEC mode, you can enter global configuration mode, giving you access to the specific router configuration modes. Using the CLI, you will configure the router name, password, and other console commands. A router’s main function is to relay packets from one network device to another. To do that, you must define the characteristics of the interfaces through which the packets are received and sent. In a TCP/IP environment, end stations communicate seamlessly with servers or other end stations. This communication occurs because each node using the TCP/IP protocol suite has a unique