扫描,放样.docVIP

上机3 扫描、放样练习 1.扳手设计（拉伸、切除、扫描） 2.盘盖零件设计（拉伸、切除、扫描切除） 3.弹簧制作（螺旋线、涡状线、扫描、曲面扫描、3D曲线）（圆柱弹簧和圆周弹簧制作） 4.花瓶制作（基准面、放样） 5.放样切除 6.第4届SW大奖赛现场考题（按照题目要求做） The Frame Create a new part.创建一个新零件 Using the drawing provided on illustration EX1-B, build the Frame. 使用所提供的工程图建模 Exhibit your ability to create extruded, swept or lofted features. 使用拉伸、扫描或放样 Use mirroring to create symmetry使用镜像创建对称物体 Save the part in your folder as: “Frame”保存文件为Frame Design Intent设计意图: The part is symmetric from left to right零件从左到右对称 The part origin is located concentric with the lower bosses零件原点与最下端圆孔同心 The interior machined surfaces labeled A and B are coplanar内机械加工表面标记为AB的面为同一个平面 The vertical member is elliptical and always tangent to both the upper and the lower bosses. 垂直部分是椭圆形的，并且总是和上下两个圆柱孔外表面相切 CAUTION: Tangency between cylinders occurs at the center plane of the cylinders only if the cylinders are of equal diameter.仅当两个圆柱孔直径相等时，相切发生在圆柱中心平面 The top and bottom radii of the I-shaped cross member are always tangent to the outside edge of the vertical member. I形的顶部和底部总是和垂直部分的外边线相切 The Upper Boss must work for the value range: .95 to 1.875 in.顶部圆柱外径可以从0.95到1.875英寸 The Lower Boss must work for the value range: 1.25 to 2.25 in.底部圆柱外径可以从1.25到2.25英寸 Scoring Criteria: The Frame评分规则 Total Value: 80 Points总分：80分 Were the bosses created as extruded features? 圆柱孔是否是拉伸特征？(5分) Change the center-to-center height from 5.5 to 7.5. Does the part rebuild correctly?将两个圆柱孔中心距离从5.5改到7.5是否有重建错误？（10分） Was the Vertical Member created using a loft or a sweep?垂直部分是否用放样或扫描完成？（10分） Change the lower boss diameter to 2.25 and the upper boss diameter to .95.将底部圆柱孔直径改为2.25和顶部圆柱孔直径改为0.95 Does the part rebuild without errors and has Design Intent been maintained?零件重建是否有错误并同时保持设计要求？（10分） Does the Cross Member remain tangent to the Vertical Member?水平交叉部分是否和垂直部分保持相切？（10分） Is the Vertical Member tangent to the Upper and Lower Bosses? 顶部和底部圆柱孔是否和垂直部分保持相切？（10分） Inspect the Upper Hole diameters