(如何在sysweld软件中应用Hypermesh软件划分的网格)HM_SYSWELD_Interface_05研讨.ppt

下载文档 降价啦

26
0
约1.02万字
约 46页
2017-03-30 发布于湖北
举报
版权申诉
保障服务

(如何在sysweld软件中应用Hypermesh软件划分的网格)HM_SYSWELD_Interface_05研讨.ppt

1、本文档共46页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

HyperMesh / SYSWELD InterfaceUser’s Guide Introduction As an integral part of SYSWELD distribution, there is provided the Geometry/Meshing module – sophisticated tool for creation of model geometry and FE mesh pre-processing. Nevertheless, to further enrich possibilities for creation of FE mesh and for import of different geometry and FE mesh data formats, there was developed the HyperMesh/SYSWELD interface. This interface allows to export models from HyperMesh into SYSWELD data file in ASCII format. To give a clear demonstration of usage of the interface, a guided example is provided in the final part of this document. Installation of the Interface Installation of the Template File The interface is provided in form of a template file. To install the interface, it is necessary to place the template file into suitable subdirectory of the HyperMesh (Altair HyperWorks) installation directory. On the next slide, there is described the installation procedure corresponding to HyperWorks version 6.0; for other versions of the HyperWorks software, the presented directory path may be slightly different. Installation Procedure The SYSWELD template file DATA_ASC_SET04 is stored on the SYSWELD Training and Toolbox CD, in directory 1_Continuation\Miscelleanous\ Hypermesh_Template In HyperMesh installation directory enter subdirectory Altair\hw6.0\templates\feoutput, where various template files are stored. Create a special subdirectory for the SYSWELD template, for example subdirectory SYSTUS. Copy the SYSWELD template file into this subdirectory. Description of Capabilities of the Interface General Functionality The interface was developed in order to enable usage of HyperMesh as FE mesh pre-processor for SYSWELD. The interface allows to create SYSWELD data file in ASCII format, which contains FE mesh (nodes and elements) and definition of Groups. The interface does not allow to export other pre-processing data defined in HyperMesh (like material properties, constraints, loa