(参选论文京沪高速公路沥青路面摊铺与碾压质量的控制.doc

参评论文 公路工程 丹通高速公路沥青路面摊铺与碾压质量的控制 中铁十五局集团第五工程有限公司第八分公司 [摘　要][关键词]包括：熨平板的宽度、拱度、初始工作仰角、布料螺旋与熨平板前缘距离、振捣梁行程等根据混合料供应能力,合理确定作业速度是提高摊铺机生产效率和摊铺质量的有效途径。V = 1 0 0 Q C / 6 0 P W H V 为摊铺机摊铺速度,m/minP 为压实沥青混合料密度,t/m3Q 为拌设备的产量,t/hW 为摊铺宽度,mH 为摊铺层压实厚度,cmC 为效率系数~3m/min，使其匀速行驶不间断，以减少波浪及施工缝，使平整度得到有效的提高。 ③摊铺厚度 根据试验段取得的松铺系数调整摊铺虚铺厚度，并在摊铺过程中随时对摊铺厚度进行检查，保证碾压完成后的沥青面层的厚度。 （3）摊铺质量控制 ①在整个摊铺过程中，摊铺作业速度应以“恒定连续”为工作准则平稳、连续进行，中途不得停机摊铺机螺旋送料器应不停顿地转动，两侧应保持有不少于送料高度的2/3的混合料摊铺机中途不许收斗防止离析，斗内两侧剩余混合料因温度较低，不得用于路面摊铺，每天摊铺结束前应清除干净注意卸料与摊铺机之间的距离，防止碰撞摊铺机或倒在摊铺机外，引起摊铺不均匀，影响路面的平整度。 保证路面达到设计的密实度和良好的平整度，是沥青路面摊铺碾压阶段的主要工作目标。达到此目的关键是要使沥青混合料在适当的温度下实施碾压。尤其是初压阶段，应尽量在规范要求的温度范围内的较高温度下短时间完成压实速度不均匀刹车和突然起步都会引起路面推移压实速度过低会使摊铺与压实工序不能很好的连接影响压实质量从而需要增加压实遍数来提高压实度速度过快, 会产生推移、横向等施工中，往轮碾上喷洒水，注意控制喷洒量，以防降低混合料温度，要采用雾状喷洒器 Subsequently, the Anhui Army military Special Branch, in Shanghais Central Intelligence Organization and the Communist party organization in Western Zhejiang Province, sent party backbone, respectively, went to Wu Jiangyan opened the Tomb, Tomb of heroic people, under the leadership of the Communist Party, fear no sacrifice and persevering, goal of the anti-Japanese revolutionary struggle. (A) stationed in Taoyuan area (Tomb of) 1, the new army of the Communist Party of China underground organization in September 1938, the CPC Zhuang Shaozhen (Zhuang Zhen, Nanxun people) by the Deputy Director of the political Department of the army on Deng Zihuis dispatch, operating from Jing County, Anhui Province, the Lake reached the Tomb, its tasks are: looking for reliable object, introduce them to the new, to expand the new team. Zhuang Shaozhen KMT-CPC cooperation as an opportunity, after classmates Yao Bi (Nanxun people, Ren Zhuxi force staff Director), introduced into the Kuomintang government political team, and as a political leader. He used this opportunity to invite progressive youth Hong Haiquan form a political team, at this point, the County Government has just been established, local school, unemployed youth are more qu