TL_52018_2011_03.pdfVIP

Adhesive Foam Tape, Adhesive-Coated on Both Sides Material Requirements 5 types: A, B, C, D, E Previous issues TL 52018: 1976-05, 1977-05, 1979-01, 1984-03, 1991-01, 1992-08, 1993-02, 1996-05 Changes The following changes have been made compared with TL 52018: 1996-05: – Section 1 Scope changed – Section 3.2.2 Shelf life changed – Section 3.3 Notes on the selection of adhesive tapes changed – Section 3.5 Design requirements for the process-reliable and functionally reliable use of adhe‐ sive tapes added – Section 4.2 Bond between adhesive tape and add-on part and Section 4.3 Bond between painted panel and add-on part: required values corrected – Table 2 changed – Section 5.2 Heat and humidity aging changed – Section 5.4 Determining the relative peel strength supplemented – Standard restructured Scope The adhesive foam tape described herein serves to fasten plastic add-on parts such as, e.g., side protective bumper strips made of EPDM+PP to painted body surfaces. These Technical Supply Specifications (TL) describe the requirements placed on the adhesive tapes as well as on the adhesive bonds produced with them. The specified values relate to adhesive bonds 1 Group Standard TL 52018 Issue 2011-03 Class. No.: 55125 Descriptors: adhesive foam tape, foam, adhesive tape, adhesive-coated on both sides, plastic, body Verify that you have the latest issue of the Standard before relying on it. This electronically generated Standard is authentic and valid without signature. The English translation is believed to be accurate. In case of discrepancies, the German version is alone authoritative and controlling. Numerical notation acc. to ISO convention. Page 1 of 9 Technical responsibility Standards Department GQL-LP/4 Hagen Rakus Tel.: +49 5361 9-22178 GQL-LP Dr. Roger Hillert EKDV/4 Ute Hager-Sü? EKDV Tel.: +49 5361 9-49035 Manfred Terlinden Confidential. All rights reserved. No part of this document may be provided to third parties or reproduced without the prior consent o