STR-S6709A电源模块.pdf

STR83145 and STR84145 LATCHED, UNIVERSAL INPUT-VOLTAGE SWITCHES Da ta S h e e t 2 8 1 9 0 Intended for power supplies with universal inputs (85 V to 265 V rms), the STR83145 and STR84145 latched, universal input-voltage switches incorporate timing, control, and drive circuitry with a high- current triac (bidirectional triode thyristor) switch. Each device senses the applied ac line potential and automatically switches the rectifier and associated capacitors between a voltage-doubler configuration (for line voltages to 141 V) and a full-bridge configuration (for line voltages greater than 149 V). This eliminates the possibility of user error with adjustable jumpers or switches. Also, the related switch-mode power stage need operate only over a reduced range of dc input voltages when compared with wide input power supplies using a bridge rectifier only. The reduction in dc input voltage range permits the use of lower- voltage capacitors and leads to a reduction in power stage stresses and power dissipation. The STR83145 and STR84145 differ only in their maximum ac current rating (10 A and 12 A, respectively). The internal sensitive-gate triac is switched by a temperature- compensated constant-current gate driver driven by a 15 kHz pulse train to reduce power dissipation. The switch-over voltage is accurately set during manufacture for consistent operation. An user-adjustable delay is provided to ensure start-up in the full-bridge mode. Once established (by an input voltage greater than 149 V rms), an integral latch holds the full-bridge mode to preclude false application of the doubler mode during brownouts, voltage droops, or missing cycles. The requirements of low transient thermal impedance and steady- state thermal resistance are satisfied in a molded, 5-lead single in-line power package. Similar input-voltage switches, with a switch point of 159 V rms, are also available. FEATURES■ Low Duty Cycle Triac Drive for Minimum Dissipation■ For Universal Inpu